LS1LT1 Forum banner
1 - 3 of 3 Posts

· Premium Member
Joined
·
13,697 Posts
96 manual will work for your 97 as it shares about 99% of the info with the 97.

Near the beginning of the wiper section there is a troubleshooting chart with step by step directions of what to check when there is no wiper activity at all.

If you don't know where to find a connector that is mentioned, at the end of the electrical section, should be a component views section, that includes most connectors.
 

· Premium Member
Joined
·
13,697 Posts
There is a rod that attaches to the high beam change over lever that goes to the actual electrical part of the headlight change over switch. This electrical part of the headlight change over switch is attached to steering column under the dash. A rod connects the lever to the change over switch.

If the rod has come out, or the change over switch is not adjusted correctly on the steering column, the lever won't click when you try to change to high beams. Or the change over switch could be broken.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top