LS1LT1 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,943 Posts
Discussion Starter · #1 ·
I'm looking for a quad pillar gauge pod for a t-top LS1 Camaro. I've got a dual right now and would like to add a N2O pressure for the kit that'll be going in my car and either a water temp or oil pressure. I'm sure I could rig up a triple and a single, but I'd really like a quad.
 

·
Registered
Joined
·
3,943 Posts
Discussion Starter · #5 ·
Chris 96 WS6 said:
Would 4 even fit?
Don't they also make just the pod that's not a whole pillar? YOu could graft that onto a triple.
I measured it out and 4 will just barely fit. If it come down to it I'm going to do what you said. That was my back-up idea from the beginning. Take a triple and then pin on single up top.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top