LS1LT1 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter #1
So I need a little help I bought a steel braided fuel line kit from speed inc for my 95 z28 to clean up some of the clutter in the bay and stuff. Well here's the problem I can't seem to get those quick disconnects fittings on the steel lines underneath the car, it seems like they don't fit but there the right size that suppose to be on there. I got the other two fittings on the fuel rail fine but not the ones on the car. What do you guys think I'm doing wrong or should try doing?
 

·
Whistles go Whoooooooooo
Joined
·
16,470 Posts

·
Registered
Joined
·
610 Posts
just requires some elbow grease.

Did you ever get them done? Mine were easy.
 

·
Registered
Joined
·
610 Posts
I just wiped mine with a towel, and the quick-connects went in, but it did require a little elbow grease.

When I did mine I WD40 the lines then wiped em down with a paper towel to make sure everything was clean and tight, they snapped right in
 

·
Registered
Joined
·
136 Posts
Discussion Starter #7
Yea I got them on I just had to clean the lines really good and dabbed a little oil on it and they went right on.
 
1 - 7 of 7 Posts
Top