Reclocked PT76GTS, what torque spec for housings?

1330 Views 4 Replies 2 Participants Last post by ShowNoMercy, Feb 14, 2013

mightyquickz28

Discussion Starter · Feb 13, 2013

I just reclocked the Turbo but I don't seem to be able to find the torque spec's on what to torque the little bolts. Do any of you good people know what the compressor and turbine bolts on the PT76GTS should be torqued to? When loosening them , it felt like it must be something in inch-pounds or a fairly light setting on ft-lbs.
Thanks!
Dave

Save

1 - 5 of 5 Posts

mightyquickz28

Discussion Starter · #2 · Feb 13, 2013 (Edited)

Just heard from Tiago on this...

Just hand tighten them. Then, with our wrench, wrist tight.

Save

ShowNoMercy

· #3 · Feb 13, 2013

Was hoping it was a little more than that, but if you get an actual number Dave let me know. I gotta tighten my housings up as well.

Save

mightyquickz28

Discussion Starter · #4 · Feb 14, 2013

I would like a tangible number too but Tiago owns a very successful turbo shop so I trust him on this.

What turbo(s) are you running?

ShowNoMercy said:
Was hoping it was a little more than that, but if you get an actual number Dave let me know. I gotta tighten my housings up as well.

Save

ShowNoMercy

· #5 · Feb 14, 2013

Same as you :lol:

Save

1 - 5 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month