LS1LT1 Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
656 Posts
Discussion Starter · #1 ·
Where can I get an oddball u joint that is 1350 on the pinion yoke and stock size on the driveshaft?
 

·
Founder
Joined
·
7,472 Posts
Online I have no idea, but the Dave's Driveshaft guy in Nashville should be able to source that for you.
 

·
Registered
Joined
·
656 Posts
Discussion Starter · #4 ·
I'll check some of them out. I emailed Lakewood over a week ago and never heard back from them. I stopped in Advance Auto and that was a joke. I was gonna get a Denny's driveshaft but I just bought this house and it's sucking up too much money right now so I'm just gonna use the stock one for now just so I can drive it and at least get a new ET with the new gears and "homemade" suspension.
 

·
Founder
Joined
·
7,472 Posts
Try Brydon at Quick Performance. He carries just about everything Moser and Strange make. I bet he has it or can tell you where to get it.
 

·
Registered
Joined
·
28 Posts
rockford driveline...Thats where I got all of my basturd joints over the years from..
 

·
Registered
Joined
·
656 Posts
Discussion Starter · #7 ·
Looked thru Summit's site a few minutes ago and they have the 1344/1350 conversion u joint. So it and the 1350 yoke is on the way! Maybe it'll get here before friday and I can run the car friday night to get some new times.
 
1 - 7 of 7 Posts
Top