LS1LT1 Forum banner

Nology Hotwires

1829 Views 3 Replies 4 Participants Last post by  race-prep
Does anyone know if the Nology Hotwires plug wires perform well on the Trans AM LS1? Thanks.
1 - 4 of 4 Posts

Get MSD's, Taylor's or Accell's if you're looking to upgrade.
Best luck is with the stockers amazingly enough. Most people won't be producing enough HP to require more stout wires. Plus the heat shields are a VERY nice feature.
I have used them and feel they are pretty good, but be careful to ground them VERY well, they are VERY pickey. I run the Taylor wires and noticed the engine runs smoother on any vehicle we put them on and the dyno pulls have shown positive results, from what we have seen here.

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.