LS1LT1 Forum banner
1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
My 1995 Z28 starts then stall with 20 seconds I have installed new fuel pump, I now have 45 lb fuel pressure ,I also changed ignition switch. If I unhook mass air sensor car starts and runs I replace mas with new one and car does same as before starts and then stalls unless I unhook mas then it runs. I checked wires one has 12 volts and another has 5 volts.does any one have ideas whats rough.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.