I'm looking for stock length or slightly smaller. I'm using stock heads that have been shaved and using stock bottom end with hotcam. I understand that my factory pushrods are hardened but being a 3pcs rod I question the riability of the stock push rods with a 100-150hp shot of nitrous.
How would the stock push rods make out with guide plates?
They would be fine with guide plates but with nitrous, your geometry better be spot on and probably want to limit your RPM's. I ran them up to 6800 for years but never with nitrous.
I'm gonna go with aftermarket ones. Even though the factory pr's are hardened, I don't wanna run in to troubles in the future. Gonna do it proper the first time concerning they're the only so far not upgraded on the top end
Thanks for the link! Assembling the top end this weekend. Hopefully have running by next weekend
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
LS1LT1 Forum
549.5K posts
33.7K members
Since 2004
A forum community dedicated to all LS1 and LT1 powered vehicles owners and enthusiasts. Come join the discussion about performance, specs, builds, conversions, swaps, modifications, troubleshooting, maintenance, and more!