LS1LT1 Forum banner
1 - 6 of 14 Posts

· Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
First off yes I replaced the flasher relay!! I converted all my lights to led and bought an aftermarket flasher relay and the turn signals stay lit like the bulb is out however it will flash when I turn the hazards on. :werd:
 

· Registered
Joined
·
80 Posts
Discussion Starter · #2 ·
Looks good just have to manually make them blink
 

Attachments

· Registered
Joined
·
80 Posts
Discussion Starter · #4 ·
I'm thinking it has something to do with the flasher relay cause it has a ground lead and it wouldn't do jack without it grounded. If anything I'll put the regular bulbs back in and the stock relay and see what happens. Thanks for the help
 

· Registered
Joined
·
80 Posts
Discussion Starter · #9 ·
You replaced the hazard relay, not the turn signal relay. You have to drop the panel under the steering wheel and its a few inches down from the rear defrost button. Napa carries the electronic flasher.
Is there two under the dash the one I replaced was almost by the trunk button. Working out of town right now don't have it with me but hopefully it'll work
 

· Registered
Joined
·
80 Posts
Discussion Starter · #11 ·
So do I need another one to make my hazards work?
 

· Registered
Joined
·
80 Posts
Discussion Starter · #13 ·
Turns I had only found the hazard relay I moved it to the turn signal one had turn-signals no hazards bought another relay and put in in the hazard spot and have both now! Thanks you guys are awesome!!!!!!
 
1 - 6 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top