LS1LT1 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
Had a question about this. The gause I have has a sending unit attached to the wires. My question is that if I use the sending unit attached will that mess with the pcm?
 

·
Registered
Joined
·
40 Posts
Discussion Starter · #3 ·
OK cool. That's what I was wandering. Thanks for the reply.

I'm not that good with wiring so where would be a good place to wire in the back light for the gauge?
 

·
Registered
Joined
·
40 Posts
Discussion Starter · #4 ·
OK. There is a place in the firewall on the pass side but I don't think the wire is long enough to reach. Is there a better place to route this from the drivers side?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top