LS1LT1 Forum banner
1 - 6 of 6 Posts

·
Founder
Joined
·
7,472 Posts
Discussion Starter · #1 ·
Couldn't get the pattern right. Pinion depth was too shallow and I was using no shims on the pinion support...aka it wouldn't go any deeper.

The 9" doesn't shim the pinion behind the bearing like in a normal housed rear. But, I think that's what's going to have to happen in this case.

I gave up and took it to a gear guy. It will be worth it to know its right.
 

·
Registered
Joined
·
1,934 Posts
True. Do you have the rest of your set-up ready to throw together, Chris?
 

·
Founder
Joined
·
7,472 Posts
Discussion Starter · #4 ·
Yes, the gears/center is at Tim's gear guy this week. The housing is painted and ready to go. Only thing left other than that is to get the bearings pressed onto the axles. I'll take those up to jeff's and borrow his press for that probably.
 

·
Registered
Joined
·
1,934 Posts
sweet! missed seeing you again this weekend, lol. I'm leaving tomorrow before noon at some point.
 

·
Founder
Joined
·
7,472 Posts
Discussion Starter · #6 ·
I have a funny feeling the first time you and I meet will be a track outing.
 
1 - 6 of 6 Posts
Top