LS1LT1 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
277 Posts
Discussion Starter #1
I bought my ta (96 slp trans am ) with an aftermarket silver face decal that was way off . I took it out took needles off repositioned the overlay . I made a diagram of where each needle was pointing . Put them back just as they were. Started up car and they all went way off . Is there anyway to reset them ? Take needles back off and retry or ? Thanks for help .

Don
 

·
Global Moderator
Joined
·
13,431 Posts
Time to take the pointers back off. It will be a trial and error type deal so try not to get frustrated if it takes several tries to get it right.

If I was doing the job, I would turn ignition on, with engine cold, and see how far off off lowest point the gauges are reading. Make notes of how far to move the pointers, then adjust them. Should be at least a good starting point.
 
1 - 3 of 3 Posts
Top