LS1LT1 Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Does anyone know of anyone making shorty headers for a 95 camaro that do not have the air fittings on them that are ceramic coated?
 

·
Chris89gta
Joined
·
727 Posts
Probably the Edelbrocks... I have seen a few sets and don't remember them having the fittings...
 

·
Registered
Joined
·
38 Posts
is jet-hot ceramic? I know that they make some headers without AIR...

edit: they only make longtubes. my bad.
 

·
Registered
Joined
·
52 Posts
I have coated edelbrocks. They have all the factory fittings and are smog legal. I bought mine used and they are probably about 10 years old. Very good quality. If you dont want LT's, which make a little more torque, then I'd recommend these. Pretty sure you can pick them up almost anywhere, get the part number from edelbrocks website so you know you have the right part number.
 

·
Registered
Joined
·
1,190 Posts
long tubes make ALOT more power through out the entire power band...
 

·
Registered
Joined
·
52 Posts
I thought that for a long time until I found a thread once with some real dyno numbers, LT's make about the HP as the shorties but low end torque ranged from 20-40 ftlbs higher. HP is likely limited buy the catback on LT equipped cars.
 
1 - 10 of 10 Posts
Top