LS1LT1 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have a 94 z28 and just ordered some pacesetter long tube headers and the y-pipe to go with it from summit racing. I have a flowmaster exhaust system on it, so is all I really need to do install the headers, and I'm good? Or what else needs to be done? Any feedback is greatly appreciated
 

·
Whistles go Whoooooooooo
Joined
·
16,470 Posts
You will need to cut the cat back pipe to get rid of the S bend, then grab a band clamp to butt connect the pacesetter Y and I pipe.

In the diagram below, the bend at 8, 9 will be cut to fit the new Y pipe.




 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
I forgot to mention also there's no catalytic converter on it now, there's just a straight 3in stainless steel exhaust pipe going back from the y-pipe to the muffler that's on there now
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top