Driveshaft durability?

1942 Views 9 Replies 6 Participants Last post by NXSLT1, Aug 18, 2005

Discussion Starter · May 10, 2005

With a Strange 12 bolt and McLeod Street Twin cluch, can I clutch dump to launch the car or is that going to cause the driveshaft to break?

The ST is impossible to slip....if I keep the dumps to 3000-3500rpm will I avoid driveshaft problems or other things such as twisting the output shaft of the transmission?

Save

1 - 1 of 10 Posts

F-Bobby

· #4 · Aug 1, 2005

you should call up Dennys driveshaft and have them make you an Aluminum one with a nice yoke on it. one of the chicks on LS1tech just destroyed her driveshaft at the track on saturday. and just in case, i hope ya have a drive shaft loop.

Save

1 - 1 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.