LS1LT1 Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1,846 Posts
Excellent cam and spring choice. What rockers are you using? If they are NSA you will NEED hardened pushrods and hardened guide plates, because the soft stock non hardened pushrods in 95-97 lt1s will wear little shavings into your engine. 92-94 lt1s came with hardened from the factory. Get a pushrods length checker and measure the needed length then surf the classifieds for used ones if needed, I got my pushrods and guide plates for $85 shipped. You could also take the gamble and find stock 92-94 pushrods if you wanted, but your quality spring and cam choice tell me you would rather do it right.
 

· Registered
Joined
·
1,846 Posts
Some say the hardened pushrods have a small divot in the end from the hardness test, I didn't look at mine close enough but didn't notice if there was one. Someone back me up on this?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top