LS1LT1 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Whats up everybody! Im new to this website. I'm just trying to get some good info. I have a lot of questions. I have a 1994 Caprice 9c1. I have been working with Lloyd Elliot. he set me up with a cam package and heads. I got a ported and polished intake. 58 mm throttle body. Also lunati roller rockers-lifters and push rods. If anybody's got any suggestions for me I would greatly appreciate it. I have a 373 positraction rear end. And I'm thinking about going with a yank 3600 tc. Thanks Daniel Wilmington NC
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #3 ·
Thank you. You wouldn't happen to know the torque specs On the cylinder heads would you? I'm definitely going with the ARP bolts
 

·
Global Moderator
Joined
·
13,567 Posts
Factory aluminum heads call for 65 foot pounds. I will assume his heads torque at the same value as he reworks stock heads. But to be on the safe side, why don't you contact Lloyd Elliot to make sure.
 
1 - 5 of 5 Posts
Top