LS1LT1 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
New to this Forum so replaced my Cam and water pump seal using the tool went pretty easy lip facing in the tool was a little difficult to get back off. I stuck the new bearings in the freezer for 20 minutes. The crank seal I forgot to get cold and bent it a little enough to want to get a new one rrrhhh. I spoke with Rob from shbox who recommended this Guy whos been doing optis for years all good reviews Optispark reconditioning service with data that it works | eBay so Im going with him. Anyone have issues getting there crank seal in I m putting them in dry but will lube the rubber on the crank seal only for start up. Thanks ,Tommy
 
1 - 2 of 2 Posts
Top