LS1LT1 Forum banner

1994 z28 windshield wiper problem!

1745 Views 2 Replies 2 Participants Last post by  steves602
Windshield wipers will turn on fine. When turned off they will not pull down into fully lowered position, they stop part way up on windshield. I am on my second motor in two years and had similar prob. with first motor. Any ideas before I buy another motor? Thanks!
1 - 3 of 3 Posts
A few thoughts:
1. You did replace the cover (with the PCB) when you have replaced the motor assembly, is that right? That is probably where the problem is located.
2. Try wiggling the 5-wire electrical connector/cable while the motor is on and see if the power drops out and stops the motor.
3. Check the wiper/wash fuse for being loose.
Thanks Doug. I will check those items and see what I find.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top