LS1LT1 Forum : LT1, LS1, Camaro, Firebird, Trans Am, Engine Tech Forums - View Profile: cocobolo95
 

cocobolo95 cocobolo95 is offline

Global Moderator

  Visitor Messages

Showing Visitor Messages 1 to 10 of 41
  1. wytch.e.1*
    06-19-2018 04:13 PM - permalink
    wytch.e.1*
    Hi. I have a 1995 Firebird Formula Convertible - Am in search of obsolete p/n 25147187 the air cleaner's rear intake duct tube hose. Found a few on ebay for over $150 - have called over 25 junkyards in DE and MD with no luck. Can you point me in a reasonably priced direction? If not, what's your take on switching to cold air intake system? What else needs to be changed if I do that? Thank you, Claudette
  2. cocobolo95
    10-16-2017 10:52 AM - permalink
    cocobolo95
    Map reading would be around 3 to 4 volts.

    Maf on my scanner doesn't read the voltage. And I can't remember what an normal idle reading should be.

    But don't lose hope. Join the forum and ask the maf question. I'm sure 1 of the members will remember the correct idle reading.
  3. Danomax6.6
    10-15-2017 11:27 PM - permalink
    Danomax6.6
    Hello! you sound like you know your stuff! may I ask you what a MAF and MAP sensor reading should be at idle?
    thank you!
    dan
  4. Zyzz
    09-24-2017 03:11 PM - permalink
    Zyzz
    Hey man,

    You always come up big for me - thank you so much.

    I'm straight retarded when it comes to wiring. When you say put 12V to connector - would I need to run wiring from the positive battery terminal to the back of the car?
  5. Workman
    08-25-2016 12:23 AM - permalink
    Workman
    Hey coco it's me Workman ! I'm having a hard time resetting my password , I didn't get an email or anything about the new switch or what ever it was .
    My Email is [email protected]
    Help please !!
  6. cocobolo95
    08-27-2015 05:08 PM - permalink
    cocobolo95
    Go to shbox.com in component view section it shows egr components. As long as you keep all components and hook ups, egr will work. That includes the one pipe that goes from exhaust manifold to back of intake manifold.

    And since your a member, you can use the regular private message. Unless there's a minimum post count to use it that I'm not aware of.
  7. bookoo91
    08-27-2015 01:42 PM - permalink
    bookoo91
    can my egr work properly without my smog aip pump set up because I deleted my smog but I want to keep my egr
  8. cocobolo95
    08-19-2015 06:41 AM - permalink
    cocobolo95
    Reasons to change fuel pressure regulator. (1) pressure is low but rises to about 43 psi when regulator vacuum hosed removed & plugged. (2) pressure drops rapidly when you shut car off. And you have eliminated fuel pump, lines, leaking fuel injectors as the problem. (3) you remove vacuum hose from regulator and gas pours out, or you smell gas in vacuum line.

    And you can post in the member private message, as you are a member.
  9. DirtyBird94
    08-18-2015 08:43 PM - permalink
    DirtyBird94
    hey cocobolo. should I replace my fuel press. reg. I'm getting aprox. 39-42 psi. kinda varies. on 94 lt1, just installed the bosch 3 24lbs injectors too. thanks
  10. cocobolo95
    09-01-2014 07:04 PM - permalink
    cocobolo95
    To ililt1 if your a registered member you can use regular private messages.

    If your laptop went into sleep mode while programing you could have damaged your pcm. So even though lt1's rarely have pcm problems, you could have that.

    Low resolution wire is red/black and high res wire is purple/white. If your scope is a dual trace scope you can do both signals at once. If you have an old single channel scope like I have, you will have to do one signal at a time.

    With engine cranking and scope leads hooked up, you will be able to see low & high res signals as opti sends them out.

  About Me

  • About cocobolo95
    Location
    Fruitland Park,Florida
    Occupation
    Luthier
    Car Year/Make/Model/
    95 Pontiac Firebird Transam

  Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: Yesterday 07:30 AM
  • Join Date: 09-22-2008
  • Referrals: 0

  Friends

Showing Friends 11 to 20 of 22

  Mentions

No results to display...

  Quotes

07-18-2018
10:15 AM - BALLSS quoted cocobolo95 in post Lt1 overheating in elky / heater valve
Question for you. Does b-body l...
06-27-2018
03:31 AM - Thomas Hamilton quoted cocobolo95 in post Buying 12 x 1.5 lug nuts 
+1.The most direct way is takin...
05-23-2018
07:09 AM - stonedstooge quoted cocobolo95 in post Coolant tank overflows
[QUOTE=cocobolo95;990914]Are your fans...
04-30-2018
01:30 PM - Featherburner quoted cocobolo95 in post Question about buying a 383
one thing jumped out at me from...
04-28-2018
04:30 PM - BALLSS quoted cocobolo95 in post Deleted Posts
03-22-2018
03:12 PM - cbr90027 quoted cocobolo95 in post Hi from France
Welcome to the forum Benoit. We...
02-14-2018
09:24 PM - Featherburner quoted cocobolo95 in post Forum or Facebook??
Only he knows for sure.Well, if...
02-13-2018
09:52 PM - Featherburner quoted cocobolo95 in post Forum or Facebook??
CKJ, 95Z, transamman25, all lef...
02-12-2018
02:00 PM - PeteD quoted cocobolo95 in post Forum or Facebook??
Funny thing Pete, but I have an...
02-11-2018
02:25 PM - Hawk177 quoted cocobolo95 in post Forum or Facebook??
Hawk177, keep it nice & keep th...
12-27-2017
02:56 PM - PeteD quoted cocobolo95 in post Hello from NC
Welcome to the forum. Thank ...
12-07-2017
12:10 PM - kris72079 quoted cocobolo95 in post Spark, Compression, fuel pressure...NO INJECTOR PULSE?
I've had the same problem for a...
11-12-2017
09:24 AM - terminal_crazy quoted cocobolo95 in post Oil inRadiator
Test it to see before removing ...
11-03-2017
05:40 PM - formula97 quoted cocobolo95 in post fuel pump prime / cold start
That's how GM gas sender units ...
10-28-2017
07:26 PM - MrCool quoted cocobolo95 in post What to Do?
Many cities have work on it you...
10-21-2017
08:32 AM - 96whitez quoted cocobolo95 in post Valvetrain suggestions for stock internals
Just adding the parts listed wi...
09-25-2017
01:47 PM - Spungo quoted cocobolo95 in post 94 lt1 engine 95 trans am included also Sold
Bump Why is this still here!...
09-23-2017
10:17 AM - MrSmokey quoted cocobolo95 in post 4l60e no lockup, no codes, trans is otherwise excellent
Glad the problem was no problem...
09-21-2017
01:48 PM - Spungo quoted cocobolo95 in post 94 lt1 engine 95 trans am included also Sold
Come on folks, this is the deal...
09-10-2017
02:40 PM - Spungo quoted cocobolo95 in post C clip will not come out
Or machine shop might be able t...
 
For the best viewing experience please update your browser to Google Chrome