Dyno Results Dual Stage small

[IndyV05]

Here's a current dyno run. It's with a small 135rwhp shot. I am shooting for 550/600 rwhp on a stock long block. Adding a third stage this winter to get a more linear torque band. Any comments, suggestions or other welcome. Oh yea, the dip is lost traction/slipping on rollers, when 2nd stage kicks in it hits pretty hard, and also suspect peak torque would have been higher.
http://home.comcast.net/~weaver.robert/wsb/media/779908/site1070.jpg

[mySStery_machine]

Looks AWESOME robert. I edited your post as the link wasn't correct. So, now the pic is viewable. I hope you don't mind. ;)

[IndyV05]

Thanks for fixing it. One thing I forgot to state, this dyno run is on the new software/Federal guidelines. Meaning, they are measuring a little diiferent than before on new cars and now applies to all. You can figure you'll lose about 10hp compared to old standard. In case you can't see it peak torque was 505, and peak hp was 480 (490).
Robert