No reverse after Shift kit installation

[sleepyTA]

I have a 95 trans am with the 4L60E in it. Before I installed the shift kit the transmission worked just fine. I put a B&M shift kit in it now it doesn't have reverse. It shifts through all the forward gears fine. I'm thinking it is in the gaskets the are on either side of the separator plate. I just need to know if it could be something else. Other things that i did include a major engine build up with a 2500 rpm stall converter. I doubt that i blew the tranny because this happen when i tryed to pull my car off the ramps. Thanks in advance for the help on this one.

Also no SES lights.

[LS13RDGEN]

Might want to check fluid level first just for giggles.
If that doesn't help, then I would start over with the shift kit. Make sure your gaskets are lined up right, all check balls in the right spot and electrical connectors plugged in.

[LS1fishtail]

*looks down*

*checks chin*

im good!

:lol:

check balls in the right spot

[CamTom12]

:lol:

[hitmanws6]

I had this same problem as well as it sliped out of 4th gear first problem my buddy bent the separator plate when he bolted it over top the that small plat that should of went on first then we went got a new plate then the gasket folded over on me what a day that was .:eek:
Got it all fixed 3 months later the trany took a crap had to get a rebuild now its all good :clown: .

[LS13RDGEN]

*looks down*

*checks chin*

im good!

:lol:

:roflmao: