Converting Manual to Power Windows.

[dlricker]

I have a 93 Z28 with manual windows, can i please get some help on how and what i need for me to convert them to power windows. Thanks, Daniel

[Grims]

DONT DOOO IT!!!!11

Well on a more serious note, the power windows in fbodys and plagues with issues, because the only motors that will work are to small to handle the huge window, So therefor they burn out prematurely.

But, sorry, no idea how the swap is done, never seen the inside of a non-power door :D

[Yoder]

It`s easy, take out the handle cranks. Get a window motor and line it up with the main window gear and drill the hole for the motor screws. I would trade you my window motors for your manual cranks.

[dlricker]

i'm going to be selling the car so thanks for the offer anyways

[CKJ]

I've never seen under the dash of a car that doesn't have power windows from the factory, but I seriously doubt that it has the cross car harness. Which is the harness that contains your reserved accessory power module and your trunk release module. Its pretty much the harness that runs from one door to the other. Its hooked into the 200 connector underneath the dash on the driver side. Its the big giant box (not the fuse box) that runs through the firewall and is screwed together to prevent it from disconnecting. The wires that it runs from is the one towards the middle of the car on the very bottom. I think it may have a total of.... 7 wires in a flat strip? Good luck if you seriously want to do this. Then on top of the wires, you'll have to get the switch panels that go on the door panels, the window regulators, and motors. To much work for me. Good luck though