View Full Version : Want to Take on an LS1
Enthusiast
08-05-2005, 12:46 AM
All of my friends drive LS1s. I want to be able to beat the fastest one. It is a stock LS1 besides a CAI, Cat-back, Eagle F1s, and some suspension mods. In an LT1 what do you think would be the quickest and least expensive way to be able to beat him at the strip. I want to have a naturally aspirated car for now. :thumbsup:
contraststriker
08-05-2005, 05:51 AM
well if you want N/A then get a 1.6 roller rocker/high duration cam setup, plus headers and full exhaust. And don't do any of that wussy hotcam crap, go big :) Unless you want good city gas mileage, in which case don't. Also get some higher ratio gears. All that should run you $1200ish.
Chris 96 WS6
08-05-2005, 07:33 AM
Best way:
Get an automatic car and put in gears and a converter, CAI & exhaust, and an XE 224/230 cam w/1.6 rockers.
Cheapest and quickest way:
150 shot of N20, but that alone might not be enough if you are playing with modded LS1s
1970judge
08-05-2005, 10:15 AM
Full exhaust,gears,converter,while your at it cam it valvetrain you will not only win but dominate.
Vendetta
08-05-2005, 12:36 PM
LE2 with supporting mods will introduce him to your taillights easy.
1970judge
08-05-2005, 12:52 PM
Good way to put it lol.
1970judge
08-05-2005, 12:52 PM
Matter a fact that goes into my sig.
Enthusiast
08-05-2005, 03:42 PM
I dont want to do gears for now because i dont want to hurt my mileage a lot. Any ideas on what a big cam will do to it?
Chris 96 WS6
08-05-2005, 03:43 PM
Cam and conveter will do it. Just be sure the car is a 3.23 geared one.
Enthusiast
08-05-2005, 05:36 PM
And what would you suggest for an M6 car?
SpAuLdIzZle
08-10-2005, 09:58 AM
personally im going with 3.73 gears pretty good for running around town...3600 stall....jet hot long tubes and a set of slicks...ill be 13.0 high 12s with that set up...then ill cam it and be mid 12s prolly among other things im also changing my exhaust when i cam it so
Chris 96 WS6
08-10-2005, 10:16 AM
And what would you suggest for an M6 car?
Gears and full exhaust.
Chad W.
08-10-2005, 10:57 AM
werd
Enthusiast
08-10-2005, 11:35 AM
I want to leave the gears stock though because it will be my daily driver. What do you all think about full exhaust and a cam?
Chris 96 WS6
08-10-2005, 12:26 PM
I want to leave the gears stock though because it will be my daily driver. What do you all think about full exhaust and a cam?
That would do it. Honestly though, with a 6 speed...gears are fine. the 6th gear is so tall..
I am running 3.73s now and I still only hit 1750rpm at 70mph.
But a cam and full exhaust should get you there, but you'll need tuning too...(PCMforless!!!)
I'd say Kooks longtubes and a 227/233 from Combination motorsports.
Do you have to worry about emissions requirements?
sleeperSS
08-10-2005, 12:58 PM
ya just cant have both IMO, if you want to go fast your gonna burn gas, bottom line. find out what you want more, performance? or economy?
Enthusiast
08-10-2005, 07:24 PM
I do have to worry about emmisions because im new to the area and i havent made any "friends" in the inspection business. Will the headers and that cam be emmissions legal?
Chris 96 WS6
08-10-2005, 07:40 PM
Depends. Where is your "area"...I don't see a location.
You're going to need cats at a mimimum to stay legal. If you are in California you can forget longtubes all together as none are C.A.R.B. legal for the LT1.
Enthusiast
08-10-2005, 09:31 PM
IM from north Texas
orbitalrider
01-13-2009, 09:54 PM
I'm in wise county and some only look to see if cats are on there. I pulled up with cut outs open and they slapped a sticker on there haha. Find the run down really old men shops haha always works. My wife was in my car and left my fans on two cops were jumpin the car off fired up open headers lol nothing was said but compliments ha. lucky i suppose they never pull me over. I raced and destroyed this mustang and the cop I'm assuming pulled the loser over cause he went for him lol. ok im rambling and off subject my bad.
myersfw
01-13-2009, 10:58 PM
Dallas,Tarrant, Johnson and Parker counties (yeah, the whole damn DFW area) have to pass the sniffer/dyno :eek: That's the only thing keeping me from a CC503....
torque_is_good
01-14-2009, 07:04 PM
sorry, new member here but a bump of a 40 month old thread???????????
happens every once in a while
94 Z28
01-15-2009, 06:03 PM
How do you even find threads this old to post in and why would you?:dontknow:
orbitalrider
01-15-2009, 06:11 PM
lol i think i missed the next button and hit the the other one that sends you too the back. cause I didn't even notice haha o well
94 Z28
01-15-2009, 06:15 PM
oh now thats a legit excuse. i didnt notice ethier but i did think it was wierd that he was saying he was going to put a cam in and in his sig it says my ac doesnt like my cam.
vBulletin® v3.8.4, Copyright ©2000-2010, Jelsoft Enterprises Ltd.