LS1freak
06-03-2009, 12:05 AM
Ok im new to the site and I want to see if anyone can help. I decided to flush my radiator fluid couple days ago and this is what i did.
I first drained my radiator fluid first by removing the petcock and took off the radiator cap.
then poored some flush fluid i was recommended to get and poored water to fill it back up.
I started my car and turn on the heater on full blast and left the car running for about 15min.
then i drained and filled it back up with water and repeated the same process until the water was clear.
then i poored the new radiator(fully concentrated)and mix it with distilled water to make 50/50. Then i would turn on and turn off my egine so the radiator water can flow and would top it off if the radiator needed more water. Then took it out for a 20 min run to see if their was any over heatment and fortunately it stayed cool. The problem is that my AC did not turn on..so im not sure what i did wrong.. can anybody help
I first drained my radiator fluid first by removing the petcock and took off the radiator cap.
then poored some flush fluid i was recommended to get and poored water to fill it back up.
I started my car and turn on the heater on full blast and left the car running for about 15min.
then i drained and filled it back up with water and repeated the same process until the water was clear.
then i poored the new radiator(fully concentrated)and mix it with distilled water to make 50/50. Then i would turn on and turn off my egine so the radiator water can flow and would top it off if the radiator needed more water. Then took it out for a 20 min run to see if their was any over heatment and fortunately it stayed cool. The problem is that my AC did not turn on..so im not sure what i did wrong.. can anybody help