Full Camaro Concept Specs

[Chris 96 WS6]

From the press kit:

Vehicle Type: Two-door, four-passenger rear-wheel drive sport coupe
Wheelbase (in / mm): 110.5 / 2806
Length (in / mm): 186.2 / 4730
Width (in / mm): 79.6 / 2022
Height (in / mm): 53 / 1344
Track (in / mm): 63.8 / 1620 front - 63.3 / 1607 rear
Engine: 6.0L V-8 LS-2. 400 HP / 298 KW. with Active Fuel Management (tm)
Transmission: Six-speed manual T56
Suspension: Four-wheel independent: MacPherson strut front, multilink rear. Progressive rate coil springs, gas-pressurized dampers
Brakes: Four-wheel disc. 14" rotors with four-piston calipers
Wheels: Cast Aluminum. 21" front, 22" rear.
Tires: 275/30R21 front. 305/30R22 rear.

[NviouSS]

they're puttting an irs on it? that's gonna suck for some people.

[tbojbob]

they're puttting an irs on it? that's gonna suck for some people.

Yea, what kinda rearend, we don't want no stinkin' 10 bolt!!! How about a freakin' Dana 60........ :lol:

[1970judge]

A buddy of mine worked at a pontiac dealer and was the one giving me all my inside news because he was in sales and he was finding stuff out. Rumor has it the rs/ss option will be back. You have a base,rs,ss,rs/ss,z28. Also The ls2 is the powerplant and he said the ls7 can be ordered. Along the same lines is the GTO gets restyled no more manaro rip off and the Judge option will be back. Pending on design it might be hard to pick between a new camaro or a judge.

[caliguy05]

question, have ne of u looked at the width of the rear tires on the concept? to me they look wider than usual, is it just cus its a concept, or do u think itll have some bearing on the production model?

[Chris 96 WS6]

Wheel/tire sizes are concept only....prod version will have probably 17s or 18s and different tires.

[gettinthere]

they're puttting an irs on it? that's gonna suck for some people.

Suspension: Four-wheel independent: MacPherson strut front, multilink rear. Progressive rate coil springs, gas-pressurized dampers

[BuiltLT1]

I hope the rear end will be a bit stronger than previous generations.

Here's a decent shot of the diff and exhaust.http://img471.imageshack.us/img471/1179/diff1vq.jpg

[Chris 96 WS6]

Looks like a CTS rear or GTO rear. Also looks like flowmasters, LOL.

[BuiltLT1]

Looks like a CTS rear or GTO rear. Also looks like flowmasters, LOL.

I would dare to say that it is a CTS rear.

[gettinthere]

I still would like to see a 12 bolt from the factory.

[1970judge]

Yah im not real game on the IRS id like a 12 bolt from the factory as well.

[Chris 96 WS6]

Don't hold your breath guys. The IRS will be used on all Zeta cars and therefore its going to be cost effective. Going to cost a lot more to re-engineer the chassis to accept a live axle that won't go in any of the other cars.

Drag racing is cool but most of these cars will not be bought by drag racers.

[gettinthere]

i know it's not gonna happen. Wishful thinking.

[1970judge]

Oh ya i no its not going to happen like he said. Wishful hope

[LiquidFire350]

Don't hold your breath guys. The IRS will be used on all Zeta cars and therefore its going to be cost effective. Going to cost a lot more to re-engineer the chassis to accept a live axle that won't go in any of the other cars.

Drag racing is cool but most of these cars will not be bought by drag racers.
as soon as it hits production, aftermarket better start making some solid axle swaps

[Transamman25]

Ya know this thing aint so bad after i keep lookin .. hey chris are those halo's (lights) up front ?

[Chris 96 WS6]

They look like halos to me.

[NviouSS]

I hope the rear end will be a bit stronger than previous generations.

Here's a decent shot of the diff and exhaust.http://img471.imageshack.us/img471/1179/diff1vq.jpg



:banana: dual exhaust from teh factory