SBC GM fastburn heads / intake combo

[11secss]

Edelbrock RPM air gap P/N 7516 intake that was used with these heads for $150
plus shipping
http://img.photobucket.com/albums/v302/11secss/Picture370.jpg

[NICETRY]

are the heads stock out of the box, or have they been worked on any? also, why do the retainers look rusty, were the heads sittinf outside, or sitting somewhere where moisture could get to them?

[11secss]

Heads have been SOLD
I have good references on other boards along with ebay (IHD2HV1) and (11secss ) on all the fbody boards

[NICETRY]

according to the link you posted, the heads aren't CNC'd. did your buddy have it done afterwards, or did he actually buy a CNC'd set from GM or Summitt, and you listed the wrong link by mistake? Also, did he install the guideplates, or did you, because they don't come with the Fastburn's standard. What brand are they?

[11secss]

descirption