Headers

[BA007]

Does anyone know of anyone making shorty headers for a 95 camaro that do not have the air fittings on them that are ceramic coated?

[gettinthere]

The only shorties I can think of would be BBK or Edlebrock.

[Fenster]

Probably the Edelbrocks... I have seen a few sets and don't remember them having the fittings...

[gettinthere]

JBA makes shorties too.

[fritotec]

2 more

[jensamin]

is jet-hot ceramic? I know that they make some headers without AIR...

edit: they only make longtubes. my bad.

[1970judge]

If your not worried abotu fittings why be worried about LT's. Go all the way.

[Flip94ta]

I have coated edelbrocks. They have all the factory fittings and are smog legal. I bought mine used and they are probably about 10 years old. Very good quality. If you dont want LT's, which make a little more torque, then I'd recommend these. Pretty sure you can pick them up almost anywhere, get the part number from edelbrocks website so you know you have the right part number.

[Jaberwaki]

long tubes make ALOT more power through out the entire power band...

[Flip94ta]

I thought that for a long time until I found a thread once with some real dyno numbers, LT's make about the HP as the shorties but low end torque ranged from 20-40 ftlbs higher. HP is likely limited buy the catback on LT equipped cars.