PDA

View Full Version : Oddball u joint

NXSLT1
10-12-2005, 01:58 AM
Where can I get an oddball u joint that is 1350 on the pinion yoke and stock size on the driveshaft?
Chris 96 WS6
10-12-2005, 08:06 AM
Online I have no idea, but the Dave's Driveshaft guy in Nashville should be able to source that for you.
gettinthere
10-12-2005, 10:59 AM
A few sponsors should have them. Basically if they carry rear ends I would expect them to carry the joints.
NXSLT1
10-12-2005, 01:33 PM
I'll check some of them out. I emailed Lakewood over a week ago and never heard back from them. I stopped in Advance Auto and that was a joke. I was gonna get a Denny's driveshaft but I just bought this house and it's sucking up too much money right now so I'm just gonna use the stock one for now just so I can drive it and at least get a new ET with the new gears and "homemade" suspension.
Chris 96 WS6
10-12-2005, 01:42 PM
Try Brydon at Quick Performance. He carries just about everything Moser and Strange make. I bet he has it or can tell you where to get it.
Kenwood
10-14-2005, 08:30 AM
rockford driveline...Thats where I got all of my basturd joints over the years from..
NXSLT1
10-18-2005, 02:49 PM
Looked thru Summit's site a few minutes ago and they have the 1344/1350 conversion u joint. So it and the 1350 yoke is on the way! Maybe it'll get here before friday and I can run the car friday night to get some new times.