Jetting suggestions

[Blackroc]

Here are the details
406 sbc
11 to 1 compression
Comp XE294 cam
Fastburn heads
Super Victor intake
Hooker long tube headers
Speed Demon 850DP carb
3.73 gears
TH 350 with 3500 stall
28 inch tall tire
86 Iroc at 3250 lbs with me.

[five7kid]

About all you can do is start as is out of the box, then adjust from there.

Typically, increment both primaries and secondaries the same until you have a good reason to do otherwise. If you have a mixture gage set up, you might be able to distinguish between primary (cruise) and secondar (wide open throttle) needs.

[ronbros]

57kid is right ,give it a go its the only way to know.

BTW, Div. 5 runner up ,you must do some tuning?

[five7kid]

Well, now it's national runner-up and former Div 5 champ - a new division champ, also from our track, was crowned September 18th.

Tuning was more of a matter of keeping it slow enough to stay above the minimum allowed dial-in for the class. Other than that, tuning for the elevation change, since consistency is the real key and that was already established.

As for jetting, another approach would be to disable the secondaries and hone in on the primary jetting. When you've got that down, hook up the secondaries and establish the correct jetting changing only the secondaries.