This question is for 93LT1Z28....

[LoudMouthFormula]

I also have a 1993 LT1 with about 140K on it and I am currently in the process of dialing in my new dynotune wet kit. You said that you have been running a 150 shot in another post, and that you haven't had any problems so far. I was just curious about your setup and what mods (if any) you made to run without any issues. I'd appreciate any advice you might have to give. Thanks.

[maverick95z]

I was wondering how that kit is workin for you?

[LoudMouthFormula]

The kit is working out great. If you're looking into buying one from Dynotune, I would definitely recommend them. They are very reasonable when it comes to price and everything has either been just as good or better compared to other brands. I think its on this site that I saw where someone did an extensive test on different nozzles from NOS, Zex, etc., and found that Dynotune hit harder than all of them. I also have installed an rpm window switch, fuel pressure cut-off switch, and a purge kit. I would highly recommend you get all three of them. The window switch and fuel switch are cheap "insurance", and the purge makes a huge difference in the hit when you spray. I also bought some NGK TR6 plugs as well, since they burn cooler and they are also gapped closer @ .35. Also, the higher the octane gas you run, the better the performance and the lesser chance of detonation. I would not suggest running 87 on spray unless you retard your timing by about 4 degrees or more. I figured this out the hard way. I filled up on 87 at the pump not thinking about my nitrous and then sprayed the next day. I'm lucky i didnt screw something up in my engine. Anyways, its been a great kit so far and I have NO complaints. If you got anymore questions just email me at jdawg7906@yahoo.com

[maverick95z]

sO WERE DID YOU GET THE KIT AND HOW MUCH WAS IT?

[LoudMouthFormula]

Go to dynotunenitrous.com. They have everything you need. They have an LT1 specific system towards the bottom of the list. I think the kit was about $390 with shipping and has everything you need. They also have tons of other stuff as well for great prices, and its all high quality stuff. I don't buy from anywhere else. The only thing I would suggest getting elsewhere is a sweet switch panel I found at nitroussupply.com. Its a panel that Nitro Dave created secifically for the '93-'97 f-bodies. It fits down in the ash tray and has switches for arming, purge, bottle heater, and bottle opener. Its only $60 I think, and its sweet. If you decide to go with this kit, let me know how it goes. There's a few little tricks I found that would definitely help out with your installation. Take it easy.